How to Make Dainty Dangle Flower Earrings: Materials: 2 Silver plated earwire 6 10 mmx6mm lucite flower beads 8 4mm bicone crystals 2 8mm pearls 2 8mm bicone crystals 8 4mm pearls 6 silver plated headpins (4 headpins 2 eyepins) is okay. 6 3mm silver plated round beads Additional Tools: Chain nose pliers Round nose pliers Wire cutters Step 1: String one silver bead and two pearls onto a headpin. Then add your flower and three other 4mm crystals at the end. Step 2: Repeat step 1 to create another dangle but only use one 4mm crystal. Step 3: Take your wire cutters and cut about 3/8ths of an inch above the last bead strung and be sure to hold the strings so the beads don't slide off. Step 4: Make a loop by gripping the very end of the wire with your round nose pliers and twist. You are going to do this with both dangles. Step 5: Create an eyepin by cutting the wire and creating a loop just as you had previously done. Step 6: Do the same with the new eyepin that you just made to create another dangle. Step 7: Use your chain nose pliers to open the loop of your ear wire and slide on the dangle with the large crystal and the large pearl and close that loop securely. Then open this bottom loop and add on these two dangles, and close that loop securely. Step 8: Repeat the previous step and you will end up with two beautiful earrings.